襄阳|襄樊步入式高低温交变湿热试验室/汽摩配件恒定湿热试验室
步入式高低温交变湿热试验室适用于仪器仪表材料、电工、电子产品、家用电器、汽摩配件、化工涂料、各种电子元器件及其他相关产品零部件在高温、低温的环境下贮存、运输、使用时的适应性试验。本试验设备主要用于对产品按照国家标准要求或用户自定要求,在低温、高温、高低温循环条件下,对产品的物理以及其他相关特性进行环境模拟测试,测试后,通过检测,来判断产品的性能,是否仍然能够符合预定要求,以便于产品设计、改进、鉴定及出厂检验用。
步入式高低温交变湿热试验室主要特点:
1、制冷机采用法国原装“泰康”全封闭压缩机。
2、冷冻系统采用单元或二元式低温回路系统设计。
3、采用多翼式送风机强力送风循环,避免任何死角,可使测试区域内温度分布均匀。
4、风路循环出风回风设计,风压、风速均符合测试标准,并可使开门瞬间温度回稳时间快。
5、升温、降温、系统完全独立可提高效率,降低测试成本,增长寿命,减低故障率。
步入式高低温交变湿热试验室主要功能:
步入式高低温交变湿热试验室主要是针对于电工、电子产品,以及其原器件,及其它材料在高温、低温的环境下贮存、运输、使用时的适应性试验。该试验设备主要用于对产品按照国家标准要求或用户自定要求,在低温、高温、条件下,对产品的物理以及其他相关特性进行环境模拟测试,测试后,通过检测,来判断产品的性能,是否仍然能够符合预定要求,以便供产品设计、改进、鉴定及出厂检验用。
襄阳|襄樊步入式高低温交变湿热试验室设备符合标准:
GB/T2423.1-2001 电工电子产品基本试验规程 试验A:低温试验方法
GB/T2423.2-2001 电工电子产品基本试验规程 试验B:高温试验方法
GB2424.1-89 电工电子产品基本环境试验规程 高温低温试验导则
GB/T2324.2-1989. GB/T2423.1-1989. GB/T2423.4-1993等国家标准
步入式高低温交变湿热试验室技术参数:http://www.jseskj.com
Dimension of the working chamber5、10、20、50、100立方米(客户需求定做)
5、10、20、50、100 m3(Customer demand for customized)
测试范围Test Range温度范围
Temperature range-20℃、-40℃、-60℃、-70℃~80℃(可选)
-20℃、-40℃、-60℃、-70℃~80℃(Optional)
湿度范围
Humidity Range5%R.H 、10%R.H 、20%R.H、30%R.H~98%R.H(可选)
5%R.H 、10%R.H 、20%R.H、30%R.H~98%R.H(Optional)
温度精度
Temperature accuracy±0.1℃
温度均匀度
Temperature evenness±2℃(局部小范围内可达到±1℃)
±2℃(Partially could be ±1℃)
湿度偏差
Humidity bias+2/-3 %R.H
升降温速率
Or cooling rate1℃、2℃、3℃、4℃、5℃/min(可选)
1℃、2℃、3℃、4℃、5℃/min(Optional)
注:以上指标均在常压、空载条件情况下测得。
Note: The above indexes are all obtained under the normal pressure and empty running
材质Material库体外壁材料
The material for the external wall优质彩钢板
High quality color steel board
库体内壁材料
The material for the internal wallSUS304不锈钢板,耐腐蚀,易清洁,美观大方
SUS304 stainless steel board, erosion resistant, easy to clean, elegant in appearance
保温材质
Heat insulation material聚胺脂硬质发泡加防火PC绝缘材料(环保材料)
Polyurethane hard foam plus fireproof PC insulation material.(Eco-friendly material)
门
Door双开门,双面全不锈钢门边耐高温防火硅橡胶二层密封,设计反锁装置防止人员入室后被锁
Double door, all stainless steel edge on both sides, sealed with two layers of heat-resistant fireproof silicone rubber. Reversely locked device to prevent persons being locked inside the chamber.
视窗
View window门上带可视窗口约300×380mm电镀膜防潮隔温观察窗
There is a view window on the door, which is about 300×380mm,and is plated for dampproof and heat insulation.
测试孔
Test hole可选择安装多个¢50mm数据线测试孔
Several ¢50mm data lines test hole can be selected to install
电源
Power380±10%v;50Hz、三相五线制;
380±10%v, 50Hz, 3 phase and 5 lines