洛阳汇工轴承科技有限公司

Thrust ball bearing is separable including a shaft washer(fit with journal) a housing washer(fit with bearing block)a group of steel balls and a cage which make it very convenient to fit with journal and bearing block respectively. Cages: Cages of thrust ball bearing are pressed steel cages machined solid cages made of brass or bronze special fabric reinforced phenolic resin cages and etc. Single direction thrust ball bearings Single direction thrust ball bearings can only be used to carry axial load in one direction but radial loas.It can make an axial location in one direction. Single direction thrust ball bearings have planar housing washer and self-aligning seat washer. Generally planar housing washer can not allow any angular error however when designing bracing structures a gap of 0.5??1mm between the outer diameter of housing washer and the fitting surface of bearing block can be kept out to correct the angular errors which would be made when mounting. Attention please aligning housing washer need to be ordered additionally. Double-direction thrust ball bearings can carry axial loads in double directions but it can not carry radial load. Double-direction thrust ball bearings can make axial locations in two directions. Double-direction thrust ball bearings also have planar housing washer and aligning seat washer. Generally planar housing washer can not allow any angular error however when designing bracing structures a gap of 0.5??1mm between the outer diameter of housing washer and the fitting surface of bearing block can be kept out to correct the angular errors which would be made when mounting. Self-aligning housing washer need to be ordered and manufactured additionally.