雷尼绍对刀仪TS27R 价格 维修 用途 性能 供应商 厂家

加工中心用刀具检测测头
产品型号：TS27R
产品名称：TS27R接触式对刀和刀具破损检测  
在机床上精确测量刀具长度和直径无需机外对刀，可对旋转刀具进行长度或直径测量而不造成刀具或测针磨损，序中刀具破损检测可识别破损的刀具，避免工件报废，通过检测长度和直径来识别刀具，发现刀具的错装，雷尼绍可靠的测头机构可在数百万次触发中保持承诺的精度，测针有弱保护结构，可防止在碰撞情况下对测头的损害，有交换工作台的机床可选用ＯＴＳ光学传输式测头。
产品描述：
TS27R接触式对刀和刀具破损检测
●加工中心用标准对刀测头
●超小型工作台安装
●精确的刀具长度和直径测量
●可检测旋转刀具而不会造成刀具或测针磨损
●测针有弱保护，可防止发生碰撞时损坏测头
About TS27R
TS27R is mounted on the machine table. It enables the user to set tool length and diameter of rotating tools， and to carry out broken tool detection.
As with all Renishaw hard-wired probe systems， TS27R requires theMI 8 interface to convert probe signals into an acceptable form for the CNC machine control.
TS27R features and benefits
•The standard tool setting probe for machining centres
•Compact table mounting
•Precise tool length and diameter measurement
•Rotating tools can be checked without wear to the tool or stylus
•Stylus is protected by a weak link， preventing probe damage in the event of a collision
TS27R specification
Specification
Sense directions  ±X， ±Y， +Z
Weight  650 g (23 oz)
Transmission type  Hard-wired
Uni-directional repeatability (max 2 sigma at stylus tip)   1.0 µm (0.00004 in)
Trigger force
Lowest force
Highest force  1.3 N (4.6 ozf)
2.4 N (8.5 ozf)
Stylus overtravel
XY plane
+Z direction  ±10°
5.5 mm (0.21 in)
Maximum recommended stylus length  Cranked stylus
27 x 33 mm (1.06 x 1.3 in)
Sealing  IP X8
Mounting  12 mm (0.5 in) T-bolt (not supplied).
Optional spiral pins to allow accurate re-mounting.
Compatible interface  MI 8 /MI 8-4

Software for TS27R
Renishawtool setting software allows you to set tool length and diameter offsets for single point and multiple point tools， perform in cycle broken tool detection and manual or automatic (programmed) positioning.